KAVAN Program Card (KAV32.42015)

Programming card for KAVAN R flight controllers (also compatible with RAY G2 controllers) is used for easy and quick programming of controllers - at home "on the table" and at the airport. The controller is connected via a servo cable, the socket is on the top of the card. The card is powered from the BEC stabilizer of the KAVAN R controller. Programming takes place with the connected engine and driving battery.

NOTE: The KAVAN R LED Programming Card cannot be used to program the 1st generation RAY controllers, and the 1st generation RAY Programming Card cannot be used to program the KAVAN R controllers.

KAVAN R controllers can be programmed in a model with an installed propeller - however, for safety reasons, we still recommend removing the propeller during programming - it will prevent a possible accident in the event of omission or operator error.

There are four programming buttons at the bottom of the card.

Using the buttons, select the program functions to be set and set their value, indicated by the lighting of the appropriate LED. The "OK" button confirms the change made and sends it to the controller, the "Reset" button is used to reset all settings and restore all values to the factory settings. The status of communication with the controller is indicated by the "Connection" LED.

Programming: Disconnect the controller servo cable from the receiver, then connect it to the socket in the upper right corner of the card labeled "BEC". Connect the drive battery to the controller; The LEDs on the card light up and show the currently set values for each function - and you can set!

The list of functions and adjustable values is given on the label on the card, a detailed description of the functions can be found in the manuals attached to the KAVAN R controllers.

Technical data:

• Power [V] : 4.8 - 6
• Length [mm] : 92
• Width [mm] : 52
• Height [mm] : 6
• Weight [g] : 26