FUTABA (FUT5102700)

S-BUS cable decoder for connecting one classic servo (analog and digital) or electronic speed controller to the S.BUS or S.BUS2 serial bus, adapted to analog and digital servos with 3.7-7.4 V (nominal), operating voltage range 3.5-8.4V

Any channel number can be assigned to the SBD-3 output (the default setting is CH3), so that the connected classic servo or controller will respond to the control signal of a given channel. Channel numbers can be assigned to the decoder output using:

• CIU-3 or CIU-2 USB programmer with SBD-Link PC utility program
• Futaba transmitter for setting the S.BUS SBD-1 servo / decoder (the SBD-3 output is set in the same way as the Sx1 output of the SBD-1 decoder): T6K, T10J, T12K, T14SG (V4.0 and higher), FX-22 (V4. 0 and higher).

Using a decoder: The SBD-3 input is connected to the S.BUS or S.BUS2 port of the receiver (or to a hub connected to the S.BUS port) and a classic servo (analog and digital) or a speed controller is connected to the output. It is also possible to connect the S.BUS or S.BUS2 servo; in this case the S.BUS / S.BUS2 servo will work classically on the channel that is set for the SBD-3 output, not on the channel saved in the servo memory.

Technical data:

• power supply (rated voltage) [V] : 3.7 - 7.4
• power supply (operation range) [V] : 3.5 - 8.4
• length with cables [mm] : 238
• weight [g] : 4.7

* Always follow the attached instructions.