GRAUPNER VOLTAGE REGULATOR PSD 5.9V (4198) DUO-SERVO

BEC module for 2 low voltage servos (6V) Allows the use of 2 low voltage servos in an installation powered by a 2S Lipo / LiIo battery.
The module has been designed and built to simplify installation as much as possible. It is connected directly to selected receiver channels, and servos requiring 6V power supply directly to the module.
BEC lowers the voltage to 5.9V and additionally transfers the control signal from the receiver's output to the servo.
This allows for quick replacement of HV servos with low-voltage equivalents without the need to rebuild the electrical installation of the model.
It is enough to plug the module into the existing installation between the servo and the receiver (similar to the servo extension cord).
Thanks to the use of this module, it is also possible to use low and high voltage servos simultaneously with HV power supply

Benefits:
- small dimensions
- uncomplicated quick assembly
- no need to modernize the electrical system of the model

Parameters:

• Input voltage 1.8 - 8.5V (2-cell LiPo)
• 5.9V output voltage

NOTE: if the supply voltage drops below 5.9V, the output voltage will be the same as the input voltage.

Total load:

• 8A for 5sec with a supply voltage of 7.4V
• 2.5A for 50sec at 7.4V supply voltage
• 1.5A for 120sec at 7.4V supply voltage