KONECT SPEED REGULATOR 40A - for brushed motors

DC regulator for 1/10 On and Off-Road, Drift, Rally, Buggy, Truggy, Short Course, Monster Truck

The 40A constant load regulator is waterproof and has a BEC which provides 5V on a 2A supply and is therefore sufficient for all areas of use common to this scale. By means of a jumper, you can easily switch between LiPo and NiMH modes without time-consuming programming. The reversing can also be easily disengaged if needed, which can be an advantage, especially in racing.
Last but not least, the controller also has a series of safety systems to protect the electronics such as the battery and the LiPo controller from damage such as overheating or too low voltage.

Specification:

• The perfect controller for almost all 1/10 scale vehicles, whether off-road or asphalt, whether it's Touring Cars, Buggies, Drift, Rally, Short Course, Monster Truck, Stadium Truck or Truggy. The DC Konect 40A WP electronic controller offers maximum driving pleasure, mega efficiency and zero hassle.
• Waterproof and dustproof regulator
• Strong 5V BEC with 2A
• Aluminum heat sink for optimal cooling during operation
• Proportional acceleration and brake for sensitive driving behavior
• Power switch
• Reverse can be turned off
• Suitable for LiPo batteries
• Complete Ready for battery and motor connection (plug & play) no soldering required

Technical data:

• Constant Current: 40A
• Peak Current: A.
• Input voltage: 2-3S LiPo, 5-9 cell NiMH / NiCd batteries
• BEC output power: 5V / 2A.
• Internal resistance: 0.002 Ohm
• Motor limitation: 2S LiPo / 6 NiMH cells = more than 12 revolutions, 550 and 540 motor speeds under 30,000 at 7.2V, 3S LiPo / 9p. NiMH = over 18 RPM, engine speed 550 and 540 RPM below 20,000 at 7.2V
• Type: brush motors (no AC)
• Connectors arrangement: Battery side: Tamiya connector, Regulator / motor: 4mm gold-plated contact sockets
• Receiver (connector type): JR / Graupner
• Dimensions approx .: 46.5 x 34 x 28.5mm
• Weight: approx. 65 g