MPX MOD. ELEK. FunJet ULTRA 2 BK / made by MPX

TheFunJet ULTRA in its time was already the fastest model on the market of lapor construction. FunJet ULTRA 2 , with the recommended ROXXY 4S drive kit, is now about 220 km/h.

The ULTRA version was designed for extreme speed. A higher gf density Elapor was used, which increased the overall stability of the model, with a slightly increased weight.

At speeds above 200 km/h, the demands on the pilot and the model's design are enormous. The ULTRA is therefore the right choice for all high-speed fans.

Despite the adaptation of the design to obtain maximum speeds, the Funjet ULTRA 2 behaves very correctly at low speeds during flight and landing.

The model is intended for advanced RC pilots !

Technical data:

• span: 783 mm
• length: 750 mm
• weight: about 875 mm

Kit contents:

• airframe elements made of ELAPOR® foam
• deep-drawn cabin cover
• aluminum - anodized engine mount
• set of small parts (levers, pushrods, snaps)
• set of decorative stickers
• instructions for assembly and operation

Required for flight:

• drive motor - recommended ROXXY BL Outrunner C35-36-1960kv
• speed controller - recommended ROXXY BL-Control 755 S-BEC
• propeller 6 "x5.5" - push propeller
• control apparatus 4 channels
• servos x2 - HS65HB recommended
• 4S LiPo / 2600mAh / 40C drive package

To completely assemble the model, you will need:

• basic modeling tools
• cyanoacrylate glue
• epoxy resin

- manufacturer: Multiplex Germany

For more information, photos and instructions, visit the manufacturer's website.

*Follow the instruction manual attached to the product and the current legal regulations for flying RC models.