SAVOX PC-02

A filter for suppressing power surges caused by inductive phenomena and a drop in the supply voltage with a sharp increase in current consumption in RC on-board equipment when using powerful analog or digital servos.

Adhesive analog servo drives or high-speed analog and digital servos can be a source of voltage spikes due to electromagnetic induction at high current flows (dynamo effect); these peaks affect the receiver supply voltage, which can thus exceed the allowable level. If you are using a redundant system with a diode * in your model, the receiver's batteries cannot suppress these spikes. This is the job for the RX capacitor.

The RX capacitor also reduces the effects of a short-term voltage drop caused by a sudden increase in current consumption that can occur when using digital servos.

Due to the use of special capacitors with high capacity and low internal resistance, the RX-Capacitor is very effective in suppressing these problems.

The RX capacitor is a way to increase the operational safety of the receiver, even if you do not use any back-up system.


Connection and installation of the RX capacitor:

1. Securely fix the capacitor RX to the model, eg with cable ties.
2. Connect the RX capacitor to any free receiver output. Do not adjust the connecting cable as this will reduce the efficiency of the RX capacitor.


Caution:
When connecting this device, be sure to connect with the correct polarity. If you are using RC equipment with other connectors, you must adhere to the terminal layout as shown: